#Icom rs ba1 software#
This software is designed to operate with Windows® 7, Windows® 8.1 and Windows® 10 on a PC with 1.8 GHz processor or better, 150 Mb HD, 1024x768 resolution. What a great way to use your HF rig while on the roadWelcome to the Lake. The IC-7300 can be connected to a PC via a USB cable and the input/output audio signal and CI-V command is sent through the USB cable. KY4BDP, Brian, uses the RS-BA1 Remote Control software to connect to the ICOM 7300. Remote control software provides a user interface, similar to the radio's front panel, and allows you to control the radio from a remote location.
System configuration software sets up IP address, audio sampling rate and other settings.Ģ. The RS-BA1 Windows® CD consists of two component software applications:ġ. Shown above in use with a dual-receive transceiver. Actually it works so much better than I expected. Ive tested the software with my IC-7300 and concluded that it works fine. The RS-BA1 Version 2 can also still be used with single-receiver transceivers. The Icom RS-BA1 software is being discussed a lot. The RS-BA1 Version 2 can also enlarge the panel size (normal or large is selectable), buttons added, clickable indicators to change settings, SUB dial added and RIT tuning knob & TX functions added. With the RS-BA1 Version 2, you can use the dual watch operation and spectrum scopes with waterfall function as well as observe the MAIN and SUB spectrum scopes. The S-Meter and SWR can even be observed. Low voice latency (caused by the RS-BA1) provides the same operational experience as using an actual radio. Most functions and modes of your Icom compatible transceiver can be controlled, including interference rejection functions and IF filter settings. The software will be updated to the following versions.The Icom RS-BA1 v2 IP Remote Control Software allows you to use an Icom compatible radio installed in another room using your home network or even from a remote location over the Internet.Merge (double-click) the 'Recover_Setup_Rsba1_Control.reg' and 'Recover_Setup_Utility.reg' extracted registry files ONLY when you need to initialize the settings of the RS-BA1. ICOM IP Remote Control Software allows you to operate your ICOM radio, even when youre not there Utilizing your home network or via the Internet, you can operate your rig thats in another room-or another region This software works with several ICOM transceivers.
#Icom rs ba1 driver#
The USB 3.0 driver for your transceiver can be downloaded in its Support/Download page.The firmware for the RC-28 is downloadable here.When you use the RS-BA1 through a USB 3.0 port, you must use a USB 3.0 driver.
#Icom rs ba1 pdf#
Instruction manual The instructions that were in the Installation guides are now included in the PDF instruction manual. The revised manual is also downloadable from the link below. RS-BA1: Version: Version 1.93: Update: 3: Major changes: Improvements RS-BA1 software No change.
#Icom rs ba1 update#